Trying to use the sensors on the NB-iot board. if i load the example the response is:
SODAQ LPS22HB Arduino Example
Connected succesfully!
Barometric sensor initialization failed!
Done with setup!
0.00 mbar
I get the same message from all internal sensors.
passtrough 
K
06.57
OK
“Signal power”,-812
“Total power”,-750
“TX power”,10
“TX time”,929
“RX time”,60594
“Cell ID”,47183461
“ECL”,0
“SNR”,250
“EARFCN”,3747
“PCI”,288
“RSRQ”,-108
OK
(on t-mobile portal no data is used)
Thanks all. resolved
1 Like