Cannot connect to network with NB-IoT Shield DeLuxe - Dual Band 8 & 20

I really need some help on this. I am trying to connect to network with NB-IoT Shield DeLuxe - Dual Band 8 & 20. It is attached to an Arduino Leonardo Shield, which is attached to a Raspberry Pi 3. I am also using a UBLOX evaluation kit with the same module (Sara N211) and the same firmware (0.67). With the evaluation kit everything runs smoothly. It gets connected to network with no problem.
Though, when I put the SIM card to the Sodaq shield, run the sketch from the http://support.sodaq.com/sodaq-one/at/ support page and send the same series of AT commands, Sodaq shield fails to connect. I have tried it many times with the same result. I am in Greece and here NB-IoT is very, very new. Though, there is no question about signal strength, since the evaluation kit gets connected and I use exactly the same specifications.
Any help will be highly appreciated.

Problem has been resolved by setting AUTOCONNECT to true.

1 Like

True: this also worked for me

AT+NCONFIG? : werkende settings ;;

+NCONFIG:AUTOCONNECT,TRUE
+NCONFIG:CR_0354_0338_SCRAMBLING,FALSE
+NCONFIG:CR_0859_SI_AVOID,FALSE