Autonomo Grove Shield

Hi Folks!

I just received my Autonomo with a Grove Shield.
To start, I connected a Seeed Chainable LED to one of the digital Grove connectors.
But it only works if I connect it to the “Always on” connectors. What do I have to do to use the “switched” connectors?

Regards,
Marco

The VCC pins of the connectors on the “switched” side are connected to switchable 3.3V_SW source.

In order to use those connectors fully you need to switch on that 3.3V_SW source.

This can be done by setting the IO pin labelled VCC_SW to OUTPUT and HIGH.

Wow. Thats a quick reply :smile:
Thanks. I will try that!